How do I make my diving board white again?
John, bleach and a brush should work on the diving board. As for the above water seats, I usually use pH up (soda ash) or baking soda, sprinkled on a wet 2-way sponge (one side has the green scrubbie surface, use the green side) to do the job, though a little bleach there will help.
What is the best way to clean a diving board?
Diving boards typically have a gelcoat surface on all four sides, with a rough textured top surface. Gelcoat is a fairly resistant surface, so you can use abrasive cleaners like Comet, Ajax, Bon Ami, or spray cleansers like our Super Tile & Vinyl cleaner to clean diving boards and dive stands.
How do you remove mold from vinyl pool?
Vinegar and Baking Soda Cleaner
Mix vinegar, baking soda and hot water in a bucket. Use a mop to clean the liner. This will kill mold and mildew and leave the liner clean and fresh smelling.
What can I use to clean the sides of my pool?
Plastic Broom. That’s right! That trusty plastic broom that helps you get rid of dust and dirt in your home and garage can also be used to help sweep and loosen debris in your pool. This makes it easier to vacuum the sides and bottom of your pool.
Can you refinish a diving board?
You can rejuvenate the appearance of your diving board by applying a fresh coat of paint. However, because the surface will be exposed to chlorine, you have to refinish it with a paint formulated to resist the chemical’s corrosive effects.
Will bleach damage vinyl pool liner?
High concentrations of chlorine (above 1.5 ppm) will attack the liner and bleach it, thus damaging it. Any level below this range will weaken its ability to kill off bacteria. The addition of chlorine to your pool water has to be done in a careful manner.
Can I use magic eraser on vinyl pool liner?
I haven’t had any problems with light scrubbing. But if you really scrub a vinyl liner with a magic eraser it can visibly scratch the liner. Often the scratches are better than the stain, but they do tend to change the appearance.